Mix the paint thoroughly before painting and, if necessary, during painting. Mix a sufficient paint in the same container for the uniform surface to avoid any shade differences. Check the shade before starting the painting by making a test painting on a piece of board or other primer with thinned petroleum oil paint, and once it dries, paint with the Uula with petroleum oil. One -time painting requires painting with plenty of paint. The surface to be painted becomes evenly beautiful when you paint carefully without retrospective paintings.

Painting conditions

The surface to be painted must be dry (less than 15 %of wood moisture, less than 80 %of the relative humidity) and at least +10 ° C. Depending on the conditions, the surface is 1-3 days after the circumstances. Counted at the earliest after 3 days. (+20 ° C and relative humidity <80 %). Drying the paint requires light and heat. Do not paint in the rain, direct sunlight or sun -heated surface. We recommend painting with a brush. When using a high pressure spray, apply the paint with a brush to spread the paint evenly. When painting with syringe, the paint should be thinned by about 10 % Uula with an oil paint thinner .

Pre -treatment

Wash the dirty surface with Uula paint cleaning and moldy surface with Uula mold cleaning . Remove the loose and poorly attached paint with a scraper, sanding, etc. Remove the old paint as well as possible. Old, thick coatings can be removed with effective Uula paint removal. Grind a grayed/fluffy wood surface. In the case of a new planed surface, grind the surface rough to ensure adhesion or allow the surface to expire 1-2 years before painting. Before the painting processing, we recommend treatment with Uula Home Protection , according to the instructions.

Priming

Previously painted wooden surfaces: Place paint on wood-clean surfaces with 20-25% thinned Uula Petrolery Oil.
Unpainted sawdance surfaces: Primer 20-25% with thinned Uula Petrolery Oil ..
Metal surfaces: Treat metal parts with anti-rust primer.
New, industrially primed wooden surfaces: No need to paint wooden surfaces.

Surface painting: Uula paint with petroleum oil once once the primer dries. One -time painting requires painting with plenty of paint. If the paint is to be thinned in one -time painting, a maximum of 10%of the thinning may be. When painting twice (eg first time in loose boards), thinning 20-40 % the first time. We recommend painting twice if the item is prone to particularly hard climate. For thinning, we recommend Uula Oil Paint thinning.

New planed, log and lamella log
surfaces The fresh planed surfaces are smooth, dense and resin and have a new absorption capacity. Paint the planed surfaces in the first year with a 30% thinned petroleum oil paint without separate primer. Make ready -made painting two years after first painting. Note that the first painting leaves the surface to be heard and the final look is only born after the finished painting.
Alternatively, the surfaces can be rolled by grinding, or they can be left to grasped with mold protection for 1-2 years before painting.

Survivability: Sawmill approx. 5 m ² /l. Fine hat or old paint finish about 7 m ² /l.

Thinnut : Uula Oil paint thinner.

Cleaning of tools: The tools are cleaned with Uula General Spirit or Lacquer Bensine and finally with soap and water.

Storage & Prevention of Environmental Harp: We recommend storage in a dry and cool place. Keep out of reach of children. Empty, dry packaging can be delivered for recycling. Liquid waste must be delivered to the hazardous waste collection point. Recycling info.

Note: Disconnect oily traders, rags, etc. by burning or watering with water before throwing in the trash due to the risk of any linseed oil self -emerging.

Please ensure the cleanliness of the painted exterior surfaces. It is a good idea to clean and protect the wood surface for the well -being and durability of the paint.