Uula Panel paint painting instructions
Uula Panel paint painting instructions for unpainted or previously painted or lacquered panel and wood surfaces in dry interiors. Uula panel paint is suitable for painting the interior walls and ceilings. The paint has an excellent coverage and adhesion, which means that the paint does not require a separate primer. The panel paint is pleasant to paint as it is already odorless when painting. Uula panel paint is easy to apply, stays well on a brush or roll, smoothes beautifully, covers well and dries quickly.
Uula Panel paint painting instructions
Mix the paint thoroughly before painting and, if necessary, during painting. Mix a sufficient paint in the same container for the uniform surface to avoid any shade differences. Do test painting with the color of your choice to make sure the tone is correct. Please note that the right shade of the paint is only visible after the surface dries. Always paint with plenty of paint, as too dry a roll or wolf can cause the unevenness of the painting and the degree of gloss. Take care of the painting environment and protect the surfaces with tape, paper, cardboard or protective plastic that remain untreated.
The method of application and the painting conditions
We recommend painting with a roller or brush, depending on the material and object to be painted. The surface to be painted must be dry, less than 80 % of the relative humidity and at least +10 ° C. The painted surface is contact dry after about 1/2 h and can be painted after about 2 hours.
Pre -treatment & topcoating
Unpainted surface: Wash the dirty surface with Uula painting according to the instructions and allow to dry properly before painting. Beat and smooth the holes and cracks as needed. Remove the sanding dust and clean the surface before painting. Paint with panel paint 2 times. If necessary, thin with water.
Old paint or lacquer surface: Remove loose and scaly paint. Carhen shiny or hard paint or varnish with sandpaper. Wash the dirty surface with Uula paint as the instructions and allow to dry properly. Beat and smooth the holes and cracks as needed. Remove the sanding dust and clean the surface before painting. Paint with panel paint 2 times. If necessary, thin with water.
Additional information
Survey: about 7 m 2 /l depending on the roughness and porosity of the substrate.
Thinnen: water
Cleaning of tools: The tools are washed with water and soap immediately after the work is completed.
Storage & Prevention of Environmental Harp: Storage in a dry and cool place. The product may not freeze. Empty, dry packaging can be delivered for recycling. Liquid waste must be delivered to the hazardous waste collection point.
First, take care of the care of painted surfaces. Always use soft, non -scratched cloths and mushrooms for cleaning. Use neutral detergents as detergents. Rinse the surfaces thoroughly.
