Mold washing from the outer surfaces

Washing mold on the outside is important for the well -being of the wood surface and the durability of the paint surface. As a natural material, wood is never uniform, but the amount of extracts in the wood and the frequency of mold spores vary in the same item or even on the same board. Mold growth The exterior surfaces of buildings have a natural phenomenon due to environmental conditions, which is not caused by the paint. Home grows on a wooden surface and does not destroy wood, so the disadvantage is mainly aesthetic. Mold can be removed by washing from the surface. Cleaning and protection should be done regularly.

In recent years, as a result of long rainy autumns, various mold and algae growths have generally been quite abundant. The problem has clearly increased today. Fuels have been broken and lead and there are no toxins in the paints that have prevented the growth of the crop. These changes contribute to the growth of mold, spores and microbes. There are spores of mold mushrooms everywhere. Under favorable conditions, they grow into an eye -catching mold growth. The breeding ground may include e.g. paint, wood, sheet metal or aggregate surface. Lika and pollen are also good mediums, so it is good to wash the dirty surfaces from time to time.

Mold mushrooms thrive in damp and warm, so the risk of mold increases in years when the autumn is long and rainy and the winter is warm. In a warm winter, the relative humidity of the air is significantly higher than in normal frost winter. In addition, the industrial drying of timber forcibly increases the risk of molding significantly, as well as felling trees during the wrong season. The occurrence of molds and living conditions vary between adjacent houses and even different parts of the house. The eaves and open porches are more likely to mold with wall surfaces, as the evaporation of moisture due to less ventilation is slower. Different shrubs and trees around the house help mold.

Uula mold detergent is mixed with water in a ratio of 1: 2, in severe cases the product can be used as a stronger dilute. The diluted mixture is about 5-7 m2/liter. Uula mold detergent is applied to the washable surface with sponge, rag, brush or low pressure spray. Allow the solution for about 10 minutes and, preferably, rinse with warm water. Cleaning results for very dirty and stubborn surfaces can be improved by brushing. The environment must be protected from splashes. The author must wear protective clothing, gloves, glasses and mask. Do not spread on wet wood surface or use the product in the rain or when threatened in the next few hours.